OldTools Archive

Recent Search Bios FAQ

262481 Ken Wright <wizard@b...> 2017‑06‑15 Question about a small Disston saw
Greeting, O Gentle Galoots!

Some time ago I bought a small backsaw at a local flea market almost
solely because of the comfort of the handle.  I put  it tin my saw till
and really haven't done much with it until today.  Closer inspection
shows a Disston & Sons medallion with the number 57 near it.  I checked
the Disstonian Institute but couldn't find a No. 57 saw listed.  It's a
short (10") backsaw with two nuts including the medallion.  The teeth
are very fine, and the front half-inch or so appear to be badly worn. 
If there is an etch in the blade, I can't see it for all the rust.

Any thoughts, ideas, or insights are more than welcome!

Ken

Registered Linux user #483005

If you ever think international relations make sense, remember this:  
because a Serb shot an Austrian in Bosnia, Germany invaded Belgium.
262490 Kirk Eppler <eppler.kirk@g...> 2017‑06‑15 Re: Question about a small Disston saw
On Thu, Jun 15, 2017 at 12:49 PM, Ken Wright  wrote:

>   Closer inspection shows a Disston & Sons medallion with the number 57
> near it.
>

Ken

Most Disston saws don't have a number stamped on the handle.  That is
probably a user's mark (school or workshop) to keep track of whose is whose.

Regarding Backsaws, most it seems are #4s.  There is a nice article on
dating etc here.  Most are marked on the back, not etched, based on my
experience of N=5 (3 stamped, 2 not)
http://hus-saws1
.wkfinetools.com/Disston/tools/Baker-
DisstonDating/datDisston-01.asp

But if it isn't a number 4, start here and guess based on # of screws
http://www.disston
ianinstitute.com/backsawpage.html


-- 
Kirk Eppler in Half Moon Bay, CA, who spent last evening botching a
resharpening on a 10" Davis #0, and will start over this weekend

Recent Search Bios FAQ