On Wed, Aug 20, 2008 at 4:41 PM, Joseph Sullivan wrote:
> How did he get his blade to turn and cut the bottoms out so smoothly?
>
According to the second paragraph under the video:
> Frank is using a bowsaw blade that was manufactured with a 90=B0 bend
> in it. So after he saws down to the bottom of the tail or pin he
> pushes the bent section of the sawblade forward into the cut. That's
> how he turns the corner so effortlessly. The sawblade isn't made
> anymore (according to Frank and our research), but boy is it amazing.
Personally, I'd like to see some more information on that blade. It's
hard to see from the video - although for the last couple tails it's
a little clearer if you look real close as he's putting the blade
into position.
------
Waylan Limberg waylan@g...
------------------------------------------------------------------------
|