OldTools Archive
Recent | Bios | FAQ |
272453 | Joe Jerkins <jerkinsjoe@g...> | 2021‑01‑06 | Re: Saw till spacing |
Yes, but not always intentional. If I were to do it over again, I'd make the front bar holding the handles a bit higher (~1/2"). At 2-1/4" it sometimes doesn't give enough "lean" to the saw so it stays in the slot. Alternatively, I could make the angle smaller by increasing the depth of the till, but that would make it stick out from the wall further (not sure if that's a pro or a con; just different) Joe Jerkins - sending emails between meetings... |
|||
Recent | Bios | FAQ |