More pictures of parts to a No. 100 Mitre Machine (some you may not even know
you are missing).
http://www.edoii.com/auction/mitreparts/img_0414.jpg
From the April 1938 Edition of the Stanley Catalogue No. 34A they are:
The rule is part MM18 ($.65)
The things on the left are part MM11 Low Clamp ($.45 per pair)
The thing on the right is the Rule Gauge and screw part MM10 ($.45)
Complete tool was listed in the Catalogue as "Stanley-Marsh Mire Machine No.
100" and sold for $33.75. Surprised it was still listed with the Marsh name as
Stanley bought Marsh in 1926, and sold of existing stock with just the Marsh
name. I looked at a 1942 catalog and still sold as Stanley-Marsh, my next
catalog is 1946 and there it is only listed as Stanley. So sometime between
1942 and 1946 the name Marsh was dropped. Of interest to probably no one, the
standard Stanley No. 34A went from being a Catalogue to a Catalog in the same
time period.
More pictures:
Gauge on ruler
http://www.edoii.com/auction/mitreparts/img_0415.jpg
Back of Gauge
http://www.edoii.com/auction/mitreparts/img_0416.jpg
Showing pressure collar on Gauge
http://www.edoii.com/auction/mitreparts/img_0417.jpg
Later Low Clamps
http://www.edoii.com/auction/mitreparts/img_0418.jpg
Earlier Low Clamps
http://www.edoii.com/auction/mitreparts/img_0419.jpg
Back of Low Clamps
http://www.edoii.com/auction/mitreparts/img_0420.jpg
Parts diagram from 1938 Stanley Catalogue No. 24A
http://www.edoii.com/auction/mitreparts/img_0421.jpg
Ruler markings for later Stanley No. 100 (2 holes with brass eyelets for wear,
and rule starts at around 7 3/8 to account for space on tool Bed Plate. Both
ends of the rule are rabbeted and have eyelets to mate with nibs on tool. The
rabbets are on opposite sides of the rule and both faces are graduated exactly
the same, vertical markings like on a Stanley No. 34 1/4 VR or No. 34 1/2 V ).
Earlier ones have a single hole.
http://www.edoii.com/auction/mitreparts/img_0422.jpg
http://www.edoii.com/auction/mitreparts/img_0423.jpg
Low Clamp installed on Stanley/Marsh No. 100
http://www.edoii.com/auction/mitreparts/img_0424.jpg
Ed O'
-----Original Message-----
The gizmo under discussion is japanned cast iron, about 5/16 thick overall with
the ruler protrusions about 5/8 on one side and 3/4 on the other. The graph
paper is 1/4 inch.
http://billwebber.galootcentral.com/1807-001.JPG
http://billwebber.galootcentral.com/1807-002.JPG
http://billwebber.galootcentral.com/1807-003.JPG
Bill W.
|
