Hi
On 2017-06-09 07:34, Derek Cohen wrote:
> Why has no one yet mentioned the use of a double iron? A Stanley #3 (my
preference over a #4) with the chipbreaker closed down will control any tearout,
and leave a clearer finish than a high cutting angle.
Steve Elliott has done a lot of great work on this question.
Note that it takes a sharp blade, a correctly shaped chip breaker, and a
very small space between the chip breaker and the edge.
Read all about it: http://planetuning.infillplane.com/
Hunt around those pages for some great science based results.
Brent
--
Brent Beach
Victoria, BC, Canada
|