On 11/22/2014 7:38 PM, Malcolm Thomas wrote:
> …if any one is still interested..
>
> someone did ask for photos/comments, so I know at least 1 person is !
>
> so progress to date… ..still need to complete a little keeper for the 4 bits
that will go with the driver - this will be installed on the left hand side.
Then oiling and then hinges/catches.
>
>
https://www.flickr.com/photos/22432327@N.../sets/72157648963620169/
>
> there are comments attached to each photo - you need to open them to read it…
>
> my comments are….quite easy of course, but time consuming to make sure the
joints are cut nicely in the soft timber. Now I know what to expect, I hope
the next one will be better.
>
> I will try cutting the next lot of joints with a Chisel only and not use the
saw at all. Should be an interesting experiment but will probably be after
Christmas.
>
Beautifully done, Mal! (sounds of cheering and hands clapping as the
crowd roars its approval)
I have but one tiny suggestion: Find some of those silica gel capsules
or sacks that come in so many things and put a couple loose in the box.
I've found that they work wonders against moisture which might tend to
accumulate in that box over time. I get my paks mostly from medicines
but sometimes from other purchased products.
Bob Hutchins
Temple, TX, USA
|