Wow! Came out great - wonderful write-up, as well. Congrats
-----Original Message-----
From: oldtools-bounces@r...
[mailto:oldtools-bounces@r...] On
Behalf Of Malcolm Thomas
Sent: Saturday, 22 November, 2014 8:39 PM
To: oldtools Tools
Subject: Re: [OldTools] advice on finger (box) joints?
.if any one is still interested..
someone did ask for photos/comments, so I know at least 1 person is !
so progress to date. ..still need to complete a little keeper for the 4
bits that will go with the driver - this will be installed on the left hand
side. Then oiling and then hinges/catches.
ht
tps://www.flickr.com/photos/22432327@N.../sets/72157648963620169/
there are comments attached to each photo - you need to open them to read
it.
my comments are..quite easy of course, but time consuming to make sure the
joints are cut nicely in the soft timber. Now I know what to expect, I
hope the next one will be better.
I will try cutting the next lot of joints with a Chisel only and not use
the saw at all. Should be an interesting experiment but will probably be
after Christmas.
Cheers
Mal
Oz
(Perth to be more precise)
|