…if any one is still interested.. 

someone did ask for photos/comments, so I know at least 1 person is !

so progress to date…   ..still need to complete a little keeper for the 4 bits
that will go with the driver - this will be installed on the left hand side.
Then oiling and then hinges/catches.

ht
tps://www.flickr.com/photos/22432327@N.../sets/72157648963620169/

there are comments attached to each photo - you need to open them to read it…

my comments are….quite easy of course, but time consuming to make sure the
joints are cut nicely in the soft timber.   Now I know what to expect, I hope
the next one will be better.

I will try cutting the next lot of joints  with a Chisel only and not use the
saw at all.  Should be an interesting experiment but will probably be after
Christmas.

Cheers
Mal
Oz
(Perth to be more precise)

On 21 Oct 2014, at 6:56 pm, Malcolm Thomas  wrote:

> my son is getting a millers falls 610 for christmas...lets see if we can
enlist another GIT....
> 
> Now i am thinking of making a small case for it inspired by the yankee 100
toolset box.  i have some nice paulownia on its way so i think that would be
ideal.
> 
> anyway, any tips/gotchas i need to be aware of when cutting these things by
hand ?? the finger joints that is...
> 
> Cheers,
> Mal
>