Malcolm asks about tool drawers...
>
> Hello,
> AM building a set of drawers for my workbench ...my tool collection seems to
be multiplying for some obscure reason :-)
>
> being inspired by the methodology depicted here.. http://woodgears.c
a/workbench/drawers.html">http://woodgears.ca/workbench/drawers.html
>
>
> I did plan to use 19mm x 19mm jarrah for the drawer slides, however i realise
that once I have seated them 4-5mm into the upright, only 15mm or so will be
left protruding to support the drawers.
>
> Is this enough ?
15mmis way over a half inch, so yes - plenty of support.
I'd say that the most important thing in such a venture is to work with more,
smaller drawers.
A large drawer takes more stuff - good - but however you make it, you have a
large mass to move to open it, and once moving, it will want to stay moving, and
you don't want several pounds(kg's) of iron and 'sharp on a stick' heading to
the floor, or the children / grandchildren's feet.
and, depending on width versus depth, a wide drawer is often more open to
racking.
As for modern, steel, ball bearing efforts and such like, well - we spit on
them. If a wooden drawer on wooden runners was goof enough in Queen Elizabeth's
day (the First, that is), well, I say it's still good enough now.
But I'm a grumpy old galoot, so I would say that.
Richard Wilson
Yorkshireman Galoot
in a gloriously sunny Northumberland.
|