Hello,
AM building a set of drawers for my workbench ...my tool collection seems to be
multiplying for some obscure reason :-)
being inspired by the methodology depicted here.. http://woodgears.ca/
workbench/drawers.html">http://woodgears.ca/workbench/drawers.html
I did plan to use 19mm x 19mm jarrah for the drawer slides, however i realise
that once I have seated them 4-5mm into the upright, only 15mm or so will be
left protruding to support the drawers.
Is this enough ? Perhaps i need to go up a notch to the 38 x 19mm ? This’ll
allow me to seat them lower in the upright and giving me more slide for the
drawers to sit on.
Whats the opinion here ?
This is the front drawer frame with the 19 x 19 slides clamped on….. look a bit
small I think …
https
://dl.dropboxusercontent.com/u/37914238/wood/Slides%201.JPG
https
://dl.dropboxusercontent.com/u/37914238/wood/Slides%202.JPG
if its any use the drawers will be 400mm wide by 500mm deep..
TIA
Cheers
Mal
Oz
(Perth to be more precise)
|