On Wed, 23 Jul 1997 04:43:10 -0500 blis8@o... writes:
>In the Ugly Chest, I found a couple of block planes. One is fairly
>easy
>even for me to identify: a Sargent low-angle block plane,
[snip]
>
>The other is a puzzler
[snip]
I have a very similar block plane marked with the Craftsman
trademark,
but I have always thought it to be make by Sargent.
>It measures 6-7/16 inches long, 2 inches wide. The blade is 1-5/8 inch
>wide, and looks to be set at the usual 20 degrees.
>
Mine is 6 1/4" long, but otherwise the same.
>It has no japanning at all, but looks like it never did - absolutely
>looks like it came this way out of the box, nice shiny steel with
>milling marks on the outside and casting pebbling on the inside.
[snip]
, and is nicely shiny steel - no japan
>or nickel.
[snip]
>The adjuster lever for the mouth looks very similar to the one on the
>Sargent low-angle, except no japan, and very unlike the ones typical
>for
>Stanley, such as on a #60. The knob is plated brass.
>
I have thought mine is nickel plated. I have no expertise in
this area
but thought the metal that was plated on the knob above the brass that is
showing
through looked like a coin more than an old bumper on a Cadillac.
Assuming tool makers would plate things in either nickel or chrome but
not steel I went with nickel. The lever cap and adjuster wheel have this
same look. What are you supposing is plated on yours?
Is the adjuster for the mouth a wheel that looks like a tie down
for a curtain
draw string. You know, one of those things you make figure-8s around
with the string
so it stays in place and kids don't hang themselves. The under side of
the adjuster wheel should have an eccentric which moves the sole plate
forwards and back. This is the adjuster I associate with Sargent.
>Two numbers appear on the underside of the cap: 307 above the hole for
>the screw, and 306 below. On the body, the words MADE IN THE USA
>appear
>in the usual spot in front of the adjuster wheel, and the number
>306-16
>is just to the rear of the mouth.
>
Mine has the 307/306 on the underside of the lever cap, but not
behind the mouth. These would be consistent with Sargent numbers.
>The wheel that adjusts blade depth turns on a screw/stud that is set
>into the bed at an angle normal (perpendicular) to the angle of the
>blade, and turning it pivots a little lever that moves the blade.
Mine has a vertical post. Could yours have been whacked out of
line?
I was too hasty in editing your original post and deleted the part about
the blade.
Mine has a blade with a lateral adjustment lever screwed to the back.
This is something else I have come to associate with Sargent. What
lateral adjuster does yours have?
[snip]
I would appreciate any comment/corrections on the assumptions I
have made above.
Regards,
Steve - who hesitated all day to respond to this because he thought he
may be way off base, but thinks how do you learn unless you stick your
neck out?
|