Nuno & John,
I just had a look at the youtube video.
I came to a couple of the same conclusions...like using the left hand
to guide the tool in the template, my pins are too thin and leaving
the center uncut also( although a small chisel makes short work of
it). Perhaps the smaller ones are better suited to longer narrower
inlays ( ribbon type?)
I'm thinking the two blades have to, when compressed, be able to clear
the shortest dimension across the template easily, but the longer they
are the more of the center is removed.
Looks like a set of these is needed!!

Regards,
Peter,
In Melbourne, Australia.
-----------------------

sgt42rhr@a... wrote,on my timestamp of 24/01/2010 1:24 AM:
> Oooh, I found a YouTube video of this in  use:
>
> http://www.youtube.com/watch?v=RlF6OTEDaXQ
>

------------------------------------------------------------------------