Material originally used was 3/4 plywood, Not quite Baltic Birch, but
not quite shop Ply either..... If I were to replace mine, I would use
3/4 Baltic or a domestic hardwood ply. More plys is better.
Solid wood seems like a better choice, but for the chance it will warp
and distort.
Using MDF was used on some later versions..... I would not repeat that
choice.....
One correction on the plans shown..... the doubled up areas are
specified as 1 1/4 wide with the 3/4 dog holes drilled at 1 1/4 from
edge to center. Means the hole is placed on the edge of the under board.
Suspect the width of the under board should be increased to 2 inches.
I am not home to check the actual dimensions of my Work Mutts....
On 8/17/2020 12:02 PM, RH Hutchins wrote:
> A set of legs for an old WorkMate has come into my hands. The top is
> long since gone. I want to replace the top. Can someone please tell
> me the dimensions (length and width) of the top pieces?
>
> I'm thinking of using oak. If you have suggestions about materials to
> consider, I'd be much obliged to hear them.
>
> Bob Hutchins
> Temple, TX USA
>
--
*Frank Filippone*
*BMWRed735i@G...*
|