>Is there a source for these X shaped bits besides finding used ones, usually in
a drill. Or NOS that has been dug up.
Never seen any in the wild, but I have converted a few yankee style. Not a task
for hand tools, but not a difficult job on a lathe or mill with a little prep,
should you have the need. I used a toolpost grinder and an indexing disk in the
lathe. I doubt I'll do it again.
*** This message was sent from a convenience email service, and the reply
address(es) may not match the originating address
On Wed, Nov 7, 2018 at 9:53 PM Bob wrote:
> Is there a source for these X shaped bits besides finding used ones,
> usually in a drill. Or NOS that has been dug up.
I just give all the GP drills I find to Greg I, who has a few GP bits, and
keep the Yankees for myself
Kirk in HMB, CA
Sent from my iPad, apologies for the Auto Correct errors. Kirk