OldTools Archive

Recent Search Bios FAQ

266988 Erik Levin 2018‑11‑08 Re: Source for Goodell Pratt drill bits.
Bob asked:


>Is there a source for these X shaped bits besides finding used ones, usually in
a drill.  Or NOS that has been dug up.


Never seen any in the wild, but I have converted a few yankee style. Not a task
for hand tools, but not a difficult job on a lathe or mill with a little prep,
should you have the need. I used a toolpost grinder and an indexing disk in the
lathe. I doubt I'll do it again.




*** This message was sent from a convenience email service, and the reply
address(es) may not match the originating address

Recent Search Bios FAQ