Greetings one and all -
I have a pair of 5/8" diameter holdfasts that I am wanting to put to work.
I drilled a 5/8" diameter hold and tried to ream it out a bit with the 5/8"
bit but the bench is 4" thick at that point (hard maple) and I clearly am
going to have to open up the holes a bit.  So here's my question - what
size hole is recommended?  I'm clearly going to have to go on-line and buy
a 21/32 bit ... or 11/16"?  I'm cheap.  I don't want to but a 21/32 and
find out it's too small - or a 11/16 and find out it's too big.
Help :)

Tom

-- 
HIPPA Privacy Statement: "IMPORTANT WARNING: This message is intended for
the use of the person or entity to which it is addressed and may contain
information that is privileged and confidential, the disclosure of which is
governed by applicable law. If the reader of this message is not the
intended recipient, or the employee or agent responsible to deliver it is
the intended recipient, you are hereby notified that any dissemination,
distribution or copying of this information is STRICTLY PROHIBITED. If you
have received this message in error, [please notify the sender immediately
and arrange for the return of or destruction of these documents."