In a message dated 1/20/00 12:48:45 PM Eastern Standard Time,
bruce_haugen@y... writes:

<<
 But I would if I could.  I can't seem to adjust it
 right.  I either get a cut so fine as to be useless,
 and the next smidgeon of a turn of the adjustment
 screw produces a hog of a cut.   >>

I've never used an ECE plane, but I've seen two things cause this problem in
other planes.  The first is if the plane has a concave sole.  The second is
if the plane iron is bowed.  put a straight edge on the sole of the plane and
across the iron at the back of the bevel.  I'll bet one of them is warped.

David