GGs;

When the handle pulled off my Olsen coping saw, I first thought of
epoxy.  But all the talk of knife and screwdriver scales got me
thinking about trying a rivet.  Someone on the porch mentioned that a
wire coat hanger could be used, so I found a fairly heavy one.  After
drilling a snug hole through the handle, I cut off a piece of the wire
and ground the ends flat, leaving about 1/8" extra length.  A couple
of minutes with a ball pein hammer and the flat on the back of my
machinist's vise. and I had a new uncle named Bob.  Handle's tight
too.

Thanks for all the knowledge and advice.

Steve
another Kokomo galoot
------------------------------------------------------------------------