OldTools Archive -- message 228896

The following shows the message you requested. To get back to the list of browse results, click the back button on your browser.

If you are thinking of subscribing to this list, please consult the OldTools FAQ.

228896

"Cliff Rohrabacher, Esq" <rohrab

Apr-12-2012

Re: "Bending" brass

Dam my eyes, but I never thought of that.

On 4/12/2012 11:28 AM, WesG wrote:
> Easiest way to put a 90 degree angle
> In brass stock is to remove 90 degrees worth of material, then bend the joint
closed and solder the joint.
------------------------------------------------------------------------